Rim Lagging, Replaceable, Diamond Groove, 1/2 in Thk, 60 to 65 Durometer, SBR, Natural Rubber

Douglas's replaceable rim lagging fits all standard manufacturers' crown face drum pulleys. It comes in engineered pre-sized sets of 2 to 5 sections, eliminating layout and cutting, along with waste and scrap pieces. This also helps save up to 70% on...

Wing Pulley, Heavy Duty, 10 in od, SBR

Wing pulleys are engineered by the professionals at douglas to be the most durable pulleys in industry and are developed using a combination of more than 40 years of experience and state of the art computer design and analysis tools. The engineered angle...

Conveyor Coupling Shaft, Steel, Protective Coating, 2 -Bolt, 2 to 3 in

Conveyor coupling shafts are used to join individual lengths of conveyor screws and allow for rotation within the hanger bearing. Steel couplings are normally furnished, however couplings with hardened bearing surfaces may be furnished where highly...

Conveyor Shaft, Steel, Protective Coating, End, 2 -Bolt, 1-1/2 to 3 in

End shafts serve to support the end conveyor section and are therefore usually supplied in cold rolled steel. End shafts are jig drilled for ease of assembly and close diametrical tolerances are held for proper bearing operation.

Conveyor Idler, Straight, 5 in Dia Roll

Fenner Dunlop’s Classic Conveyor idlers utilize centrifugal self-cleaning seals, which ensure their bearings reach their designed life. In addition, their grease-free sealing elements result in much lower friction values than conventional designs. Their...

Drum Pulley, Standard, Heavy Duty, 16 in od, 26 to 32 in

Douglas's standard heavy-duty drum pulleys meet or exceed CEMA/ANSI specifications. They feature an exclusive one-piece rolled-in crown in all sizes -- this helps to ensure consistent, proper belt tracking, resulting in a stronger pulley with tighter...

Conveyor Shaft, Steel, Protective Coating, End, 2 -Bolt, 2 to 3 in

End shafts serve to support the end conveyor section and are therefore usually supplied in cold rolled steel. End shafts are jig drilled for ease of assembly and close diametrical tolerances are held for proper bearing operation.

Conveyor Screw, Helicoid, 141 in Lg, Steel, Right Helicoid Flight

The letter “H” indicates screw conveyor with helicoid flighting. The figures to the left of the letter indicate the nominal outside diameter of the conveyor in inches. The first figure following the letters is twice the diameter of the couplings in...

SUPERIOR Series 80 Conveyor Troughing Idler, 20 degree, 5 inch, CEMA-C, 18 to 36 in

Superior’s CEMA-B idlers are made with precision-ground lifetime-lubricated 17mm ball bearings that feature positive lip-contact Trash Guard seals. A specially design die-cast zinc nut, combined with a delrin seal, forms a deep groove labryinth seal...